46 47
CUSTOM SETUP
Custom setup allows each user to customize flash setup to suit his or her preferences.
Setup procedure
1. Tu rn the Macro Flash Controller on.
2. Press and hold the MODE button for more than 2 sec-
onds, until the setup mode display appears in the control
panel.
3. Tu rn dial A to select the setup mode.
4. Tu rn dial B to select the value.
5. Press the MODE button to exit from setup and return to
the previous control panel display.
Setup mode
Mode display
Dial A
Value display
Dial B
Function Default
AF illuminator
lamp
LAMP timer
Light intensity
adjustment
Guide number
display
Guide number
Unit of distance
AF illuminator is activated according to the control
from the camera.
AF illuminator is defeated.
The lighting time of the modeling lamp can be set.
Selectable time: 1" (1 sec.) ~ 10", 15", 20", 25", 30",
40", 50", 60" and – –" (3 min.)
Light intensity cannot be adjusted.
Light intensity can be adjusted.
The light intensity in MANUAL mode is displayed in
terms of light intensity ratio.
The light intensity in MANUAL mode is displayed in
terms of guide number.
Guide numbers are displayed in meters.
Guide numbers are displayed in feet.
A
30"
OFF
OFF
m
ALL RESET
All Reset resets the custom setups to the factory default settings.
• Press the MODE and LIGHT buttons simultaneously for 2 or
more seconds to reset the custom setups (except for the
distance display unit (m/ft)) to the default settings.
• The distance display unit (m/ft) is not altered by the all reset
operation.
• Restore the Ring Flash (RING) and Twin Flash (TWIN) modes
respectively.
WARNING DISPLAY LIST
Warning details Control panel display Remedy
The Ring Flash or Twin Flash
is not connected.
The Twin Flash light ratio is
improper.
• Flash emission with the se-
lected light ratio is not pos-
sible in Manual mode.
• The display disappears automatically in
about 4 seconds. When the display has dis-
appeared, connect the Ring Flash or Twin
Flash.
• The display disappears automatically in
about 4 seconds.
• When the display has disappeared, re-con-
nect the Ring Flash or Twin Flash.
〜
•Set the proper Twin Flash light ratio or light
intensity ratio.
MACRO FLASH CONTROLLER
FC-1
MODE
LAMP
AUTO
CHECK
TEST/
CHARGE
POWER
LIGHT
RATIO GN/
MACRO FLASH CONTROLLER
FC-1
MODE
LAMP
AUTO
CHECK
TEST/
CHARGE
POWER
LIGHT
RATIO GN/
Connection failure during or
connector disconnection dur-
ing power ON.
• Custom setup can be performed separately for the Ring Flash (RING) and Twin Flash (TWIN).
To Next Page
Loading...
Need help?
General
