EasyManuals Logo
Home>Olympus>Camera Accessories>PT-059

Olympus PT-059 User Manual

Olympus PT-059
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
EN 43
EN
Remove any sand, dirt, etc.
After visually checking that dirt has been removed from the O-ring, check
for attached sand and other foreign matter, as well as for damage and
cracks by squeezing the entire circumference of the O-ring lightly with
your fi ngertips.
Remove attached foreign matter from the O-ring groove with a lint-free
clean cloth or a cotton swab. Also remove any sand or dirt attached to any
part of the Case that comes into contact with the O-ring.
When a sharp object is used to remove the O-ring or to clean the inside of the O-ring
groove, the Case and the O-ring may be damaged and water leakage may be caused.
When the O-ring is checked with the fi ngertips, take care not to stretch the O-ring.
Never use alcohol, thinner, benzene or similar solvents or chemicals detergents to
clean the O-ring. When such chemicals are used, it is likely that the O-ring will be
damaged or that its deterioration will be accelerated.
How to Apply Grease to the O-ring
1
Apply the exclusive
lubricant to the
O-ring
Make sure that your ngers and the O-ring
are free of dirt, then squeeze the appropriate
amount of exclusive lubricant onto a fi nger to
spread onto the entire circumference of the
O-ring (approx. 15 mm is adequate).
2
Spread the lubricant
all over the O-ring.
Apply the lubricant with 3 fi ngers and spread
it over the O-ring. Be careful not to use force
as this may stretch the O-ring.
3
Check that the O-ring
is free of scratches
or unevenness.
After spreading the lubricant, check visually
and by touch that the O-ring is not scratched
and that its surface is at. If it is damaged in
any way, be sure to replace it with a brand-
new O-ring.
Always perform maintenance of the waterproof function even when the Case has
been opened every shooting. Neglecting this maintenance may cause water leakage.
When the Case is not to be used for a long time, remove the O-ring from the groove to
prevent deformation of the O-ring, apply a thin coat of silicone grease, and store it in a
clean plastic bag or the like.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Olympus PT-059 and is the answer not in the manual?

Olympus PT-059 Specifications

General IconGeneral
MaterialPolycarbonate
Case typeHard case
Mountable on-
Product typeCamera Case
CompatibilityTG-6
Product colorBlack, Red, Silver
Waterproof up to45 m
Brand compatibilityOlympus
Protection featuresWaterproof

Related product manuals