28
EN
Depending on the subject or the situation (if the
distance between the camera and subject is too
short), the image may not look 3D.
The 3D viewing angle varies depending on the
subject, etc.
To exit 3D shooting mode without saving an image,
press the button.
The [Image Size] (p. 32) is fi xed to [0].
The zoom ratio is fi xed.
The focus, exposure and the white balance are fi xed
when the fi rst image is taken.
The fl ash is fi xed to [$Flash Off].
Shooting with special effects
(
P
mode)
To add expression to your photo, select the desired
special effect.
1
Set the shooting mode to
P
.
2
Use HI to select the desired effect and then
press the A button to set.
MENUMENU
2 3
0.00.0
AUTO
WB
AUTO
WB
12M
1
12
Pop Art
Icon indicating
P
mode
that is set
Shooting mode Option
Magic Filter
1 Pop Art
2 Pin Hole
*1
3 Fish Eye
4 Drawing
*1, 2
5 Soft Focus
*1
6 Punk
7 Sparkle
*1
8 Watercolor
*1
9 Refl ection
0 Miniature
a Fragmented
b Dramatic
*1
The [Image Size] (p. 32) of the retouched image is limited
to [n] or lower.
*2
Two images are saved, an unmodifi ed image and an
image to which the effect has been applied.
In
P
mode, the optimum shooting settings are pre-
programmed for each scene effect. For this reason,
some settings cannot be changed in some modes.
The selected effect is applied to the movie. The effect
may not be applied depending on the shooting mode.
Recalling saved settings
(C1, C2 Mode Setup)
Modes C1 and C2 are used to take pictures using custom
settings saved using the [Custom Mode Setup] (p. 45)
option in the setup menu.
1
Set the shooting mode to C1 or C2.
To Next Page
Loading...
Need help?
General
