_ Inthe ISO setting, although smaller values result in
less sensitivity, sharp images can be taken under fully
lit conditions. Larger values result in higher sensitivity,
and images can be taken at fast shutter speeds even
under low light conditions. However, high sensitivity
introduces noise into the resulting picture, which may
give it a grainy appearance.
Pictures are taken sequentially while the shutter button
is held down.
_! Select the drive option in the function menu.
"_The shooting speed varies depending on the settings
for [Image Size] (p. 33) or [Compression] (p. 36).
_ When set to [_]lJi] or [Hir_3zJj],[Image Size] is limited to
[1_1_1]or lower, and the ISO sensitivity is fixed to [ISO
Auto].
_ When set to [[:_3], the flash (p. 20) cannot be set to
[Redeye]. When set to other than [_] or [C_] ], the
flash is fixed to [@)Flash Off].
_ When set to [_]lJi] or [H_r_3zJJ],the digital zoom (p. 37) is
not available.
_ With settings other than [_], the focus, exposure
end the white balance are fixed when the first frame
is shot.
Selecting the image size for still
images (Image Size) ...............................................................................................
Select the image size option in the function
Use <][:> to select the setting option, and
press the (o_ button to set.
One frame is shot each time the
shutter button is pressed.
The images are taken sequentially
E_3*_ while holding down the shutter for up
to 100 frames.
The camera takes sequential shots
H_r_JJ at approximately 15 frames/sec.
The camera takes sequential shots
H_r_zJJ at approximately 60 frames/sec.
EN
To Next Page
Need help?
General
