Adjusting the image processing
function [Pixel Mapping]
_ (Se_tings Menu 2) _ Pixe] Mapping
_ This function has already been adjusted at factory
shipping, and no adjustment is needed right
after purchase. Approximately once a year is
recommended.
_i_ For best results, wait at least one minute after taking
or viewing pictures before performing pixel mapping.
If the camera is turned off during pixel mapping, be
sure to perform it again.
Adjusting the brightness of the monitor
d..m./]
I' (Se_tings Menu 2) _ Irml ...................................................................................
To adjust the monitor brightness
,_', Use/kV to adjust the brightness while viewing the
screen, and then press the _) button.
To adjust the image processing function
Press the (_) button when [Start] (Submenu 2) is
displayed.
• The check and adjustment of the image processing
function starts.
Playing back images on a TV [TV Out]
........t(S_ingsM_u IyQut : : : : : ..........................
NTSC Connecting the camera to a TV in North America, Taiwan, Korea, Japan,
NTSC/PAL and so on.
PAL Connecting the camera to a TV in European countries, China, and so on.
480p/576p Set the signal format to be given priority. If the TV setting does not match,
HDMI Out 720p
it is changed automatically.
Off Operate with the camera.
HDMI Control
On Operate with the TV remote control.
_ The factory default settings differ according to the region where the camera is sold.
EN
To Next Page
Loading...
Need help?
General
