Bypass: This preset bypasses ALL processing and should be used for test purposes only or as a convenient way to
listen to the unmodified source audio for comparison.
Bass Enhancement
Omnia.ONE Studio Pro has the power to shake the walls with low end! If your source material has it, Omnia.ONE
Studio Pro can expose that deep bass and do it with muscle! Tailoring the bass is simple, and is done by adjusting
the following parameters and in the order listed:
1. Increase the amount of Bass boost in the Enhance section.
2. NOTE: Engaging the “Bass Boost” section will increase the delay time of the audio through the unit by 2.1
ms, so if minimizing the delay throughput is important in your application, leave the “Bass Boost” setting
on “Bypass” and use the following techniques for bass enhancement.
3. Increase the Drive to Low Frequency Limiter.
4. Increase the Release setting in the Low Frequency Limiter.
Just as in the section on ‘overdoing’ processing, again moderation is the key. If all of the above changes are made in
unison there is a possibility of severe low frequency buildup. This would unbalance the audio spectrum and produce
the illusion of “lost” presence and high frequencies.
To Next Page
Loading...
Need help?
General
