Omron E5CK Datasheet

Digital Controller E5CK I-75
Temperature
Controller
■ Parameters Operation
Level 0 Mode
0
1 3 0 0
0
s p - m
50.0
o
c
- o
50.0
r - 5
run
PV/SV
Set Point During SP Ramp
Monitors the set point when the SP ramp function is used.
MV Monitor (Heat)
MV Monitor (Cool)
Used when the Unit is in heating and cooling control operation.
Run/Stop
The process value is displayed on the No.1 display and the set point is displayed on the No.2 display.
When the multi-SP function is in use, the value of whichever is set, set point 0 or 1, is linked.
1
off
s e c r
k e y p
0 1 2 34
xxxx
xxx
xxx
xxx
xx
x
16.0
3 8. 8
Security
A/M Key Protect
Invalidate the function of the A/M Key.
MV Manual
Mode Set value
Calibration
Option
Expansion
Setup
Level 2
Level 1, 0
Process value
Manipulated variable
MANU indicator
Any mode marked with "X" in the following table is not displayed on the menu when this parameter is set to
"0" to "3."
The Unit will be in only level 0 mode and the menu will not be available when this parameter is set to "4" to
"6."
Only the "PV/SP monitor" and "set point" parameter can be used when this parameter is set to "5."
Only the "PV/SP monitor" parameter can be used when this parameter is set to "6."

Omron E5CK Specifications

General

Brand	Omron
Model	E5CK
Category	Controller
Language	English