162 LD Cart Transporter User's Manual 14766-000 Rev H
10.7 î ±Removing and Installing LD Platform Cart Transporter Covers
Figure 10-10. Sonar Connectors, with Connectors Exposed
4.
Tilt the cover down to about 45°, and slide the brace on the bottom of the cover out of
its clip.
This will separate two pairs of magnets, so you will feel some resistance at first.
Installing Covers
The covers can be installed in the reverse of the order in which they are listed above.
l
The front upper and rear outer covers must be installed first and second.
l
The access panel must wait for the left side cover.
Bumper Cover
This is the only cover that requires tools to install.
1.
Place the cover on the bumper.
It is held on with magnets, as well as screws.
2.
Install the screws, removed during the cover removal, at the sides of the cover.
Front Upper Cover
1.
Grip the cover at the two outer edges.
2.
Align the bottom edge of the cover so it slides under the chassis support.
3. Tilt the top of the cover into position.
To Next Page
Loading...
Need help?
General
