46 LD Cart Transporter User's Manual 14766-000 Rev H
3.4 î ±Setting Up an LD Platform Cart Transporter
Figure 3-8. Wheel Pin Hole Location
For each side of the platform:
a.
Remove the side cover a small distance from the platform. Refer to Removing
Covers on page 159.
The light disc PCA cable will still be attached.
b.
Disconnect the cable from the light disc PCA, so the side cover can be moved
completely away from the platform.
This will fully expose the wheel and tire.
c.
Lift the wheel slightly to relieve pressure on the pin.
d.
Remove the pin by pulling the ring that is attached.
These pins can be used for later service of the entire drive assemblies.
Figure 3-9. Wheel Pin
To Next Page
Loading...
Need help?
General
