5．Applicable Devices and Device Configuration
5. Applicable Devices and Device Configuration
5.1. Applicable Devices
The applicable devices are as follows:
NJ501-[][][][]
NJ301-[][][][]
EtherCAT Slave for Motion
Control
Servomotor
Stepping motor
Servo amplifier
Stepping motor drive
Precautions for Correct Use
As applicable devices above, the devices with the models and versions listed in Section 5.2.
are actually used in this document to describe the procedure for connecting devices and
checking the connection.
You cannot use devices with versions lower than the versions listed in Section 5.2.
To use the above devices with versions not listed in Section 5.2 or versions higher than those
listed in Section 5.2, check the differences in the specifications by referring to the manuals
before operating the devices.
This document describes the procedure to establish the network connection. Except for the
connection procedure, it does not provide information on operation, installation or wiring
method. It also does not describe the functionality or operation of the devices. Refer to the
manuals or contact the device manufacturer.
(Hivertec, Inc. http://www.hivertec.com/)
This URL is the latest address at the time of this document creation. Contact each device
manufacturer for the latest information.
Contact the device manufacturer for servomotors and stepping motors connectable to the
EtherCAT Slave for Motion Control.
(Hivertec, Inc. http://www.hivertec.com/)
To Next Page
Loading...
Need help?
General
