1
Parameter
sx
1
sx
2
7 6 5 4 3 2 1 0
s0 07 06 05 04 03 02 01 00
s1 15 14 13 12 11 10 09 08
s2 23 22 21 20 19 18 17 16
s3 31 30 29 28 27 26 25 24
Bit ON: Function key is ON
Bit OFF: Function key is OFF
Example
Function keys number 5, 6, 29, 31 are ON
s0
1
s0
2
s1
1
s1
2
s2
1
s2
2
s3
1
s3
2
= 600000A0
Description This command is used by the DF type PTs and some DN type PTs. If the Screen
Attribute (bit input/function key) screen is displayed, the change in the bit status
corresponding to a pressed function key or the change of status of an input ter-
minal is reported to the host computer with this command.
The host computer is notified each time a function key or inputterminal ON/OFF
status changes.
Comment Function keys allocatedas keys on a numeric keypad are not notified when they
are pressed for number setting.
5-2-7 Touch Switch Bit Output
Format
1B
[ESC]
4A
J
s0
1
s0
2
s1
2
s2
1
s2
2
s31
s1
1
s3
2
OD
[CR]
s0 to s3: Touch switch status (2-digit hexadecimal)
The correspondence between the bit representation in s0 to s3 and
the touch switch number is shown in the following table.
Parameter
sx
1
sx
2
7 6 5 4 3 2 1 0
s0 07 06 05 04 03 02 01 00
s1 15 14 13 12 11 10 09 08
s2 23 22 21 20 19 18 17 16
s3 31 30 29 28 27 26 25 24
Bit ON: Touch switch is ON
Bit OFF: Touch switch is OFF
Example
Touch switch numbers 0, 3, 21, 27 are ON
s0
1
s0
2
s1
1
s1
2
s2
1
s2
2
s3
1
s3
2
= 09002008
Description If theScreen Attribute “bit input/touch switch” screenis displayed, the changein
the bit status corresponding to a pressed touch switch is reported to the host
computer with this command.
The host computer is notified each time a touch switch status changes.
5-2-8 Lamp and Touch Switch Display Status Response
Format
1B
[ESC]
n
1
n
2
m
1
53
S
% $&
Section 5-2
To Next Page
Loading...
Need help?
General
