2-2SectionCPU
11
2-2 CPU
The CPU is available in three models. The C200H-CPU01-E and C200H-
CPU11-E
both run on 100 to 120 or 200 to
240 V
AC, and the C200H-CPU03-E
runs
on 24 VDC. The C200H-CPU1
1-E is
unique in that it connects the SYSMAC
LINK
Unit or SYSMAC NET Link
Unit to the CPU. These two Units are mounted
to
either
of the two slots located directly to the left of the the CPU and connected
to
the CPU via a bus connector
. A separate Unit, the Bus Connector Unit, is re
-
quired to
connect the SYSMAC NET Link Unit or the SYSMAC LINK Unit to the
CPU.
Also note that model C200H-CPU11-E has an additional battery connected to
the
CPU.
Note If you are using the SYSMAC LINK Unit or SYSMAC NET Link Unit in your
C200H system, use model C200H-CPU11-E as the CPU. Otherwise, the link
Units cannot be used.
C200H-CPU01-E/03
Power fuseIndicators
Detachable
terminal block
Peripheral device
mounting hole
Handheld Programming Console connector
Remove cover to gain access to connector.
Programming Console connector
(Peripheral device connector)
Remove cover to gain access to connector; store cov-
er in cover storage slot.
Programming Console
connector cover storage slot
Memory Pack
connector
Downloaded from Elcodis.com electronic components distributor
To Next Page
Loading...
Need help?
General
