8-1
8. Reconfiguring Voltage and Frequency
AS MANUFACTURED
The genset was set up and adjusted at the factory
for the frequency and voltage stated in the “As
Manufactured” block on the nameplate (Fig-
ure 8-1). If it is necessary to reconfigure voltage
and/or frequency for the application, follow the in-
structions in this section.
RECONNECTION LABEL
The genset manuals were shipped with a sheet with
peel-off reconnection labels (Figure 8-2) to apply
over the “As Manufactured” block on the genset
nameplate (Figure 8-1) when reconfiguring the
genset for the application. Apply the appropriate la-
bel if different from the “As Manufactured” data
block.
CHANGING FREQUENCY
The genset control box has jumper leads marked
HZ SEL and 60 HZ.
1. Connect HZ SEL and 60 HZ for 60 Hz output ;
disconnect HZ SEL and 60 HZ for 50 Hz output.
2. Apply the appropriate reconfiguration label.
RECONNECTING GENERATOR
If necessary:
1. Reconnect the generator for the application
voltage in accordance with the appropriate
generator connection schematic on Page A-2.
2. Apply the appropriate reconfiguration label.
3. Adjust voltage, if necessary. See ADJUSTING
VOLTAGE (p. 8-2).
Note:It may be necessary to change circuit breakers
to provide required protection or full genset power
when reconnecting the generator.
FIGURE 8-1. “AS MANUFACTURED” BLOCK ON
NAMEPLATE
FIGURE 8-2. TYPICAL RECONNECTION LABELS
Redistribution or publication of this document,
by any means, is strictly prohibited.
To Next Page
Loading...
Need help?
General
