Onkyo C-7070 User Manual

En-15
Basic Operation
To turn on the CD Player, press the [ ON/STANDBY]
button on the unit or the remote controller. Press the
[ ON/STANDBY] button again to set the CD Player to
Standby.
You can specify that if the CD Player is left stopped for
30 minutes, the power will automatically turn off,
placing the unit in Standby mode (Auto Standby
function).
On the North American model:
The default setting is “Off”.
On the European model:
The default setting is “On”.
Make settings for this function while playback is
stopped.
1
Press the [SETUP] button.
2
Use the [] or [] button to display “ASb”;
then press the [ENTER] button.
3
Use the [] or [] button to switch “Off” or
“On”; then press the [ENTER] button.
4
“COMPLETE” appears on the display.
If this setting is “On,” the ASb indicator will be lit.
Notes:
• If an iPod/iPhone is connected, ASb will not operate
because the connected unit is being charged.
• If playback is paused, the power will remain on even
after 30 minutes have elapsed; the Auto Standby
function will not operate.
• If Auto Standby is “On,” the “ASb” indicator will
blink approximately 30 seconds before Auto Standby
operation occurs.
Press the remote controller’s [DIMMER]
button repeatedly to select the following
options:
Turn down the volume, then connect your stereo
headphones (ø 6.3 mm, 1/4 inch phone plug) to the
[PHONES] jack.
You can adjust the volume by using the [PHONES
LEVEL] knob.
Turning On CD Player
Setting Auto Standby (ASb)
ON/STANDBY
123
ENTER
SETUP


Changing the Display Brightness
Using Headphones
DIMMER
Normal Dim Dimmer
PHONES
jack

Onkyo C-7070 Specifications

General

Frequency range	2 - 20000 Hz
Audio formats supported	MP3, WMA
Signal-to-Noise Ratio (SNR)	116 dB
Total Harmonic Distortion (THD)	0.0025 %
CD-RW playback	Yes
CD changer	No
Device type	HiFi CD player
Product color	Black

Weight and Dimensions

Depth	413 mm
Width	564 mm
Height	200 mm
Weight	8600 g