Onkyo C-7070 User Manual

En-29
Troubleshooting
If you have any trouble using the CD Player, look for a solution in this section.
Can’t turn on the C-7070.
• Make sure that the power cord is properly plugged into the wall outlet (page 14).
• Unplug the power cord from the wall outlet, wait five seconds or more, then plug it in again.
There’s no sound.
• The C-7070 is not connected properly. Check all connections and correct as necessary.
• The wrong input source is selected on your amplifier. Check your amplifier’s input source setting. Refer to your
amplifier’s manual.
Can’t play a CD.
• The disc is upside down. Load the disc with the label-side facing up (page 16).
• The disc is dirty. Remove the disc and clean it (page 12).
• Condensation has formed inside the C-7070. Unplug the power cord and leave the unit for two to three hours in the
room temperature until the condensation has evaporated.
• The disc is nonstandard. See “Disc Notes” on page 11.
CD playback skips.
• Install the C-7070 in a location that is free of vibration.
• The disc is dirty. Remove the disc and clean it (page 12).
• The disc is very scratched. Replace the disc.
Can’t enter track numbers for memory playback.
• No such track on the CD. Enter another number (page 22).
It takes a long time to locate certain tracks.
• The disc is dirty. Remove the disc and clean it (page 12).
• The disc is very scratched. Replace the disc.
Can’t access the SETUP menu.
• If any track has been selected even when the C-7070 is stopped, you must place it into the full stop state by pressing
the [] button before you can view all the SETUP menus. However, settings can be made while USB is selected and
an iPod/iPhone or USB flash device is playing.
Power
Audio
CD
SETUP
If you can’t resolve the issue yourself, try resetting the CD Player before contacting your Onkyo dealer.
With the CD player stopped, press the [SETUP] button, then use the [  ]/[  ] buttons to make the display indi-
cate “INITIAL”, and press the [ENTER] button. Next, use the [
 ]/[  ] buttons to make the display indicate
“Execute”, and press the [ENTER] button. When the display indicates “Clear”, the player has been reset.
Note that resetting the CD Player will delete your custom settings.

Onkyo C-7070 Specifications

General

Frequency range	2 - 20000 Hz
Audio formats supported	MP3, WMA
Signal-to-Noise Ratio (SNR)	116 dB
Total Harmonic Distortion (THD)	0.0025 %
CD-RW playback	Yes
CD changer	No
Device type	HiFi CD player
Product color	Black

Weight and Dimensions

Depth	413 mm
Width	564 mm
Height	200 mm
Weight	8600 g