1 Updating the Firm Ware
1-1 Open the DISC tray and set the Firm Ware Recorded DISC on DISC1 bay.
1-2 Close the DISC tray.
Will start the Firm Ware updating automatically.
Will tray open after finish the updating.
1-3 Take out the disc.
2 Test mode
2-1 Press the "STOP" & "DISPLAY" at the same with NO DISC condition.
Current version number of sub-micon is displayed on the FL tube.
2-2 Press the "DISPLAY".
Current microprocessor version number of BACK END displayed on the FL tube.
The REGION code will display on the monitor display.
MDD1N : REGION code 1 MPA4P : REGION code 4
2-3 Press the "DISPLAY".
Current microprocessor version number of FRONT END is displayed on the FL tube.
2-4 Press the "DISPLAY".
All segment of FL tube light up.
2-2 Press the "DISPLAY".
Will be displayed "DISPLAY KEY" on FL tube.
2-6 Press any keys except "STANDBY".
The function name of pressed key is display on the FL tube.
Press each key and confirm that the name of pressed key.
2-7 Press "STANDBY" to exit the test mode.
3 Dimmer control
Press "DIMMER" key and confirm the Dimmer control.
Even press the "DIMMER" key, Luminance of FL tube change as follows.
FL tube : Bright Dark1 Dark2 Dark2 Bright
Center light : ON ON ON OFF ON
4 Destination setting
R757 R758 Destination Region Code TV mode
MDD1N OPEN 2.7K North America 1 NTSC
MPA4P 0 ohm OPEN Australia 4
PAL / AUTO
DV-CP701
UPGRADE THE FIRMWARE/ TEST MODES
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
http://www.xiaoyu163.com
http://www.xiaoyu163.com
To Next Page
Loading...
Need help?
General
