69
En
If you’ve connected your Zone 2 speakers to the AV
receiver, as explained in “Connecting Your Zone 2 Speak-
ers Directly to the AV receiver” (➔ 68), you must set the
“Powered Zone2” setting to “Act” (Activated).
Note
• Powered Zone 2 cannot be used if “Speakers Type(Front)” is
set to “Bi-Amp” (➔ 44).
• This procedure can also be performed on the AV receiver by
using SETUP, arrow buttons, and ENTER.
This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust the
volume for Zone 2.
Controlling Zone 2 from the AV receiver
Setting the Powered Zone 2
1
Press RECEIVER followed by SETUP.
The main menu appears onscreen.
Tip
• If the main menu doesn’t appear, make sure the appropri-
ate external input is selected on your TV.
2
Use q/w to select “Speaker Setup”, and then press
ENTER.
The “Speaker Setup” menu appears.
3
Use q/w to select “Speaker Settings”, and then
press ENTER.
The “Speaker Settings” menu appears.
4
Use q/w to select “Powered Zone2”, and use e/r
to select:
` Not Act
:
Use FRONT WIDE/ZONE 2 L/R terminals to
connect front wide speakers (Powered Zone 2
disabled).
` Act:
Use FRONT WIDE/ZONE 2 L/R terminals to
connect Zone 2 speakers (Powered Zone 2
enabled).
5
Press SETUP.
The setup menu closes.
2. Speaker Setup
1. Speaker Settings
2. Speaker Configuration
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
2–1. Speaker Settings
Speaker Impedance
Speakers Type(Front)
Powered Zone2
6ohms
Normal
Not Act
Using Zone 2
1
To turn on Zone 2 and select an input source, press
ZONE 2 followed by an input selector button
within 8 seconds.
Zone 2 turns on, the ZONE 2 indicator lights.
To select AM or FM, press TUNER input selector
and ZONE 2 repeatedly.
To select the same source as that of the main room,
press ZONE 2 twice. “Zone 2 Selector: Source”
appears on the display.
2
To turn off Zone 2, press ZONE 2.
ZONE 2 indicator flashes.
Press OFF.
The zone is turned off, and the ZONE 2 indicator
goes off.
ZONE 2
OFF
ZONE 2 indicator
Input selector buttons
To Next Page
Loading...
Need help?
General
