Before Using the AV receiver
,::"",
,-".,.;-
'.
-
:".
.:;
setting
th.e
Voltage
Selector
(on
somemodels).'
.,
. .
.--=-:,y
Some models have a voltage selector switch for compat-
ibility with power systems around the world. Before you
plug in this model, make sure that the voltage selectoris
set to the correct voltage for your area.
If
it isn't, use a
small screwdriver to set it
as
appropriate. For example, if
the voltage in your area
is
120 volts, set the selector to
"120V."
If
it's between 220 and 240 volts, set it to "220-
240V."
Notes:
•
If
the remote controller doesn't work reliably, try
replacing the batteries.
• Don't mix new and old batteries or different types
of
batteries.
•
If
you intend not to use the remote controllerfor a long
time, remove the batteries to prevent damage from
leakage or corrosion.
• Expired batteries should be removed as soon as possi-
ble to prevent damage from leakage or corrosion.
""~
"~
,~,~,;Q
j'
VOLTAGE
SELECTOR
To
use the remote controller, point it at the
AV
receiver's
remote control sensor, as shown below.
Remote control sensor
AV receiver
Approx.
16
ft.
(5 m)
InstaUingriheBatteries
.
. '
~
. ;
1
To
open the battery compartment, press
the small hollow and slide open the cover.
Notes:
• The remote controller may not work reliably ifthe AV
receiver is subjected to bright light, such as direct sun-
light or inverter-type fluorescent lights. Keep this in
mind when installing.
•
If
another remote controller
of
the same type is used in
the same room,
or
the
AV
receiver is installed close to
equipment that uses infrared rays, the remote control-
ler may not work reliably.
• Don't put anything, such as a book, on the remote con-
troller, because the buttons may be pressed inadvert-
ently, thereby draining the batteries.
The remote controller may not work reliably
ifthe
AV
receiver is installed in a rack behind colored glass
doors. Keep this in mind when installing.
• The remote controller will not work ifthere's an obsta-
cle between it and the
AV
receiver's remote control
sensor.
Slide the cover shut.
2 Insert the two supplied batteries (AAlR6)
."
in accordance with the polarity diagram
inside the battery compartment.
19
To Next Page
Loading...
Need help?
General
