For
European Models
We, ONKYO EUROPE
ELECTRONICS GmbH
LIEGNITZERSTRASSE 6,
82194 GROEBENZELL,
GERMANY
4
Precautions-Continued
For British models
Replacement
and
mounting
of
an AC plug
on
the power
supply cord
of
this unit should
be
performed only by
qualified service personnel.
IMPORTANT
The
wires in the mains lead are coloured
in
accordance
with the following code:
Blue: Neutral
Brown: Live
As
the colours
of
the wires in the mains
lead
of
this
apparatus may not correspond with the coloured mark-
ings identifying the terminals in
your
plug,
proceed
as
follows:
The
wire which is coloured blue
must
be
connected to
the terminal which is marked with the letter N
or
coloured black.
The
wire which is coloured brown
must
be
connected to
the terminal which is marked with the letter L
or
coloured red.
IMPORTANT
The
plug is fitted with an appropriate fuse.
If
the fuse
needs to
be
replaced, the replacement fuse
must
approved byASTA
or
BSI
to
BS
1362
and
have the same
ampere rating as that indicated
on
the plug.
Check
for
the ASTA mark
or
the
BSI
mark
on
the
body
of
the fuse.
If
the power
cord's
plug is not suitable for
your
socket
outlets, cut it
off
and fit a suitable plug.
Fit
a suitable
fuse
in
the plug.
Declaration
of
Conformity
(E
decla~e
i~
ow.n
.respon~ibility,
that the ONKYO product
descnbed
III
thiS
Illstructlon manual is in compliance with the
corresponding technical slandards such as EN60065
EN55013, EN55020 and EN61000-3-2, -3-3. '
GROEBENZELL, GERMANY
~
K.
MIYAGI
ONKYO EUROPE ELECTRONICS GmbH
Memory Backup
The
AV
receiver uses a battery-less
memory
backup
system
in
order
to
retain radio presets and
other
settings
when
it's
unplugged
or
in
the case
of
a
power
failure.
Although no batteries are required, the
AV
receiver
must
be
plugged into an AC outlet in
order
to
charge the
backup
system.
Once
it
has been charged, the
AV
receiver will retain the settings for several weeks,
although this depends
on
the environment
and
will
be
shorter in humid climates.
Speaker Precautions
Placement
•
The
subwoofer cabinet is made
out
of
wood
and
is
therefore sensitive to extreme temperatures
and
humidity,
do
not
put
it
in locations subject
to
direct
sunlight
or
in
humid
places,
such
as near an air condi-
tioner, humidifier, bathroom,
or
kitchen.
•
Do
not
put water
or
otherliquids close to the speakers.
If
liquid is spilled
over
the speakers, the drive units
may
be
damaged.
• Speakers should
only
be
placed
on
sturdy, flat surfaces
that are free
from
vibration. Putting them
on
uneven
or
unstable surfaces, where they
may
fall and
cause
dam-
age, will affect the
sound
quality.
• Subwoofer is designed to
be
used in the upright verti-
cal position only.
Do
not use it in the horizontal
or
tilted position.
•
If
the unit is
used
near
a turntable,
CD
player
or
DVn
player, howling
or
slipping
of
sound may occur. To
prevent this, move the unit away from the turntable,
CD
player
or
DVD
player, otherwise lower the
unit's
output
level.
Using
Close
to
a
TV
or Computer
TVs
and
computer
monitors are magnetically sensitive
devices and
as
such are likely to suffer discoloration
or
picture distortion
when
conventional speakers are
placed nearby. To prevent this, the SKF-360F/SKF-
318F
and
SKC-360C/SKC-318C feature internal
mag-
netic shielding. In some situations, however, discolora-
tion
may
still
be
an issue,
in
which case you should turn
off
your
TV
or
monitor, wait IS to
30
minutes, and then
turn
it
back
on
again. This normally activates the
degaussing function, which neutralizes the magnetic
field, thereby removing any discoloration effects.
If
dis-
coloration problems persist, try moving the speakers
away
from
your
TV
or
monitor. Note that discoloration
can
also be caused by a
magnet
or
demagnetizing tool
that's too close
to
your
TV
or
monitor.
Do
not place SKM-360S/SKM-318S close to
TV
or
a
computer monitor because they have no magnetic shield.
Input Signal
Warning
The
speakers
can
handle the specified input power when
used for normal music reproduction.
If
any
of
the fol-
lowing signals are fed to them, even
if
the input power is
within the specified rating, excessive current may flow
in the speaker coils, causing burning
or
wire breakage:
I.
Interstation noise from an untuned FM radio.
2. Sound from fast-forwarding a cassette tape.
3. High-pitched sounds generated by an oscillator,
electronic musical instrument, and so on.
4. Amplifier oscillation.
5. Special test tones from audio test
CDs
and so on.
6.
Thumps
and clicks caused by connecting
or
discon-
necting audio cables (Always turn offyour amplifier
before connecting
or
disconnecting cables.)
7. Microphone feedback.
To Next Page
Loading...
Need help?
General
