Using the Tuner
Press theTUNING Up
or
Down
[~]I[~]
button.
Searching stops when a station is
found.
• Auto Tuning Mode
~-----------
Pressthe [TUNING MODE] button
so
that
the
AUTO
indicator
appears on the display.
With the built-in tuner, you can enjoy AM and FM radio
stations. You can store your favorite stations as presets
for quick selection.
Press and
hold
theTUNING Up
or
Down
[~]I[~]
button.
The frequency stops changing when
you release the button.
Press the buttons repeatedly to change
the frequency one step at a time.
TUNED
AUTO
~-------I
I~
IFn
'."
"_,
Pi
!!~-'::-:;:p
FMSTEREO
• Manual Tuning Mode
~-----------
Pressthe[TUNING MODE] button
so
that
the
AUTO
indicator disap-
pears from the display.
TheAmerican model changes FMfrequency in 0.2 MHz
steps, 10 kHz steps for AM. For other models it's
0.05
MHz
steps for
FM
and 9 kHz
or
10
kHz steps
for
AM.
When tuned into a station, the TUNED indicator
appears. When tuned into a stereo FM station, the FM
STEREO indicator appears on the display, as shown.
Tuning into weak
FM
stereo stations
If
the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
Note:
•
You
canalso use the remote controller's Up and Down
[.]/[~]
buttons to tune the radio.
Use the [TUNER]
input
selector
button
to
select either AM
or
FM.
In this example, FM has been selected.
k;
ti·
:3
;.::'
n I
.:::~
ti
h
~:.':
..... .....
I
Band
Frequency
(Actual display depends on country.)
Press the [SETUP] button
to
dis-
play "0. Hardware Setup," and
then press [ENTER].
Use the Up and Down
[.]I[~]
buttons
to
select
"AM
Freq;' and
then use
the
Left and Right
[
....
]I[~]
buttons
to
select:
10
kHz:
Select
if
10 kHz steps are
used in your area.
9
kHz:
Select
if
9 kHz steps are used
in your area.
Press
the
[SETUP] button.
Setup closes.
Here you can specify the AM frequency step used in
your area. When this setting is changed, all radio presets
are deleted.
AM
Frequency Step Setup
(not
North America
and
Europe)
Note:
• This procedure can also be performed on the remote
. controllerbyusing its [SETUP] button, arrow buttons,
and [ENTER] button.
41
To Next Page
Loading...
Need help?
General
