Connecting
Your
Speakers-Continued
3116"
- 7/16"
(5 mm) - (10 mm)
Wall
/
~
._
.
--
.
I---
The
speakers
can
easily
be
wall mounted by using the
keyhole slots. To prevent the speaker from vibrating
against the wall, attach two
of
the supplied thick rubber
stoppers to the rear
of
each speaker.
To mount the front
or
surround speakers vertically, use
the keyhole slot shown to hang each speaker on a screw
that's securely screwed into the wall.
HTP-360 Front/Surroundspeakers
(SKF-360F/SKM-360S)
Use screws with a head diameter
of
5/16" (9 mm)
or
less
and a shankdiameter
of
1/8" (4 mm)
or
less. With hollow
walls, use a cable/pipe detector to check for any power
cables or water pipes before making any holes.
Leave a gap
of
between
3/16" (5 mm) and 7/16"
(10 mm)betweenthe wall
and the base
of
the screw
head, as shown.
(We recommend that you
consult a home installa-
tion professional.)
~
Keyhole slot for
wall mounting
D
o
ThiCk~~
rubber ,
stoppers
\)
(';,
;)
Threaded inserts for machine screws are provided
on
the
rear
of
each speaker for wall-mounting with commer-
cially available speaker mounts
or
brackets. North
American models require ll4-inch screws. Othermodels
require M5 (5 mm) screws. Refer to the manual supplied
with your mounts or brackets for installation details.
ill
Y Threaded
;7iI1
insert
0
D
~
0
Threaded insert
~~
D~~~
~
HTP-318 Front/Surround speakers
(SKF-318F/SKM-318S)
~
Keyhole,slot for
,..----
wall mounting
'===
Thick
~
rUbber~O
II
stoppers I
~
~
To mount the center speaker horizontally, use the two
keyhole slots shown to hang each speaker on two screws
that are securely screwed into the wall.
Center
speaker (SKC-360C/SKC-318C)
o
Threaded insert
~
Keyhole slots for wall mounting
rr
D·
Thick
A3=1
~:=:::=:==""'=:::::::::~===j==jl
rubber
stoppers
8-9/16"
(217
mm)
Caution:
A mounting screw's ability to support a speakerdepends
on how well it's anchored to the wall.
If
you have hollow
walls, screw each mounting screw intoa stud.
If
there are
no studs, orthe walls are solid, use suitable wall anchors.
Note:
• The portion
of
the screw that goes into the speaker's
threaded insert should
be
between 1/4" - 5/16" (5 mm
-8
mm) long.
Mount or bracket
/
~-~
1/4" (North American model)
~-t
5 mm (01hermodels)
1/4" - 5/16"
(5 mm) - (8 mm)
22
To Next Page
Loading...
Need help?
General
