EasyManuals Logo
Home>Onkyo>Speaker System>LS3100

Onkyo LS3100 User Manual

Onkyo LS3100
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
3
En
16. Object and Liquid Entry
Never push objects of any kind into the
apparatus through openings as they may touch
dangerous voltage points or short-out parts that
could result in a fire or electric shock.
The apparatus shall not be exposed to dripping
or splashing and no objects filled with liquids,
such as vases shall be placed on the apparatus.
Don’t put candles or other burning objects on
top of this unit.
17. Batteries
Always consider the environmental issues and
follow local regulations when disposing of
batteries.
18. If you install the apparatus in a built-in
installation, such as a bookcase or rack, ensure
that there is adequate ventilation.
Leave 20 cm (8") of free space at the top and
sides and 10 cm (4") at the rear. The rear edge of
the shelf or board above the apparatus shall be
set 10 cm (4") away from the rear panel or wall,
creating a flue-like gap for warm air to escape.
Precautions
1. Recording Copyright—Unless it’s for personal
use only, recording copyrighted material is
illegal without the permission of the copyright
holder.
2. AC Fuse—The AC fuse inside the unit is not
user-serviceable. If you cannot turn on the unit,
contact your Onkyo dealer.
3. Care—Occasionally you should dust the unit all
over with a soft cloth. For stubborn stains, use a
soft cloth dampened with a weak solution of
mild detergent and water. Dry the unit
immediately afterwards with a clean cloth. Don’t
use abrasive cloths, thinners, alcohol, or other
chemical solvents, because they may damage the
finish or remove the panel lettering.
4. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR
THE FIRST TIME, READ THE FOLLOWING
SECTION CAREFULLY.
AC outlet voltages vary from country to country.
Make sure that the voltage in your area meets the
voltage requirements printed on the unit’s rear
panel (e.g., AC 230 V, 50 Hz or AC 120 V, 60
Hz).
The power cord plug is used to disconnect this
unit from the AC power source. Make sure that
the plug is readily operable (easily accessible) at
all times.
For models with [POWER] button, or with both
[POWER] and [ON/STANDBY] buttons:
Pressing the [POWER] button to select OFF
mode does not fully disconnect from the mains.
If you do not intend to use the unit for an
extended period, remove the power cord from
the AC outlet.
For models with [ON/STANDBY] button only:
Pressing the [ON/STANDBY] button to select
Standby mode does not fully disconnect from
the mains. If you do not intend to use the unit for
an extended period, remove the power cord from
the AC outlet.
5. Preventing Hearing Loss
Caution
Excessive sound pressure from earphones and
headphones can cause hearing loss.
6. Batteries and Heat Exposure
Warning
Batteries (battery pack or batteries installed)
shall not be exposed to excessive heat as
sunshine, fire or the like.

Other manuals for Onkyo LS3100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo LS3100 and is the answer not in the manual?

Onkyo LS3100 Specifications

General IconGeneral
Product colorBlack
RMS rated power- W
Recommended usageHome theatre
Remotely operatedYes
Audio output channels2.1 channels
Amplifier frequency range50 - 20000 Hz
Signal-to-Noise Ratio (SNR)93 dB
Total Harmonic Distortion (THD)0.8 %
Amplifier dimensions (W x D x H)187 x 120 x 32 mm
Satellite speaker type2-way
Satellite speaker weight700 g
Number of satellite speakers2
Satellite speakers RMS power40 W
Satellite speaker frequency range200 - 20000 Hz
Satellite speaker dimensions (WxDxH)169 x 108 x 78 mm
Subwoofer typeActive subwoofer
Subwoofer weight5800 g
Subwoofer frequency range40 - 200000 Hz
Subwoofer drivers quantity1
Subwoofer dimensions (WxDxH)261 x 269 x 337 mm
Subwoofer driver diameter (imperial)6.3 \
Power sourceAC
AC input voltage230 V
AC input frequency50 Hz
Bluetooth version2.1+EDR
Weight and Dimensions IconWeight and Dimensions
Set weight10500 g

Related product manuals