13
En
■ Wall mounting
Note
• For mounting the front
speaker, use a screw with a
head diameter of 2/32" (7 mm)
or more and 5/16" (9 mm) or
less, and a shank diameter of
1/8" (3 mm) or more and
5/32" (4 mm) or less. The
screws as thick and long as
possible are recommended.
• Leave a gap of between 5/32" (4 mm) and 3/16"
(5 mm) between the wall and the base of the screw
head, as shown.
• Mount the front speaker to the vertical wall.
Mounting to the inclined wall might cause a falling
of the speaker by coming off the stand.
■ Fixing the front speakers to prevent a
falling accident
When you mount the speaker to the wall, make
sure to set it firmly so that it cannot slip and
fall. This is especially important if you have
small children. Pass the end of the supplied
wire through the hole of the stand and tie it.
Screw the eye bolt into the eye bolt hole on the
back of the cabinet.
Note
• A mounting screw’s ability to support a speaker
depends on the material and the position of studs of
the wall (We recommend that you consult a home
installation professional).
■ Using the rubber stoppers for a more
stable platform
We recommend to use the supplied rubber
stoppers to achieve the best possible sound.
Attach the rubber stoppers to the four corners
of the bottom. The rubber stopper also provides
stability.
1
Attach the supplied stand referring to
the illustration for wall mounting.
2
Screw a commercially available wall-
mounting screw into the wall.
3
Insert the head of the screw into the
keyhole slot on the bottom of the
supplied stand and fix it firmly.
Please confirm that the head of the screw
is at the top of the hole.
Screw
Keyhole slot for wall
mounting
Wall
5/32" to 3/16"
(4 to 5 mm)
Placing the Subwoofer
2
1
Thin rubber stoppers
Bottom of the SLW-301
To Next Page
Loading...
Need help?
General
Weight and Dimensions
