63
Basic Operations—Continued
You can adjust the bass and treble for the front speakers,
except when the Direct, Pure Audio or THX listening
mode is selected.
■ Bass
You can boost or cut low-frequency sounds output by the
front speakers from –10 dB to +10 dB in 2 dB steps.
■ Treble
You can boost or cut high-frequency sounds output by
the front speakers from –10 dB to +10 dB in 2 dB steps.
Notes:
• This setting is not available when the multichannel
Analog input is selected.
• To bypass the bass and treble tone circuits, select the
Direct, Pure Audio or THX listening mode.
You can display various information about the current
input source as follows.
Note:
This procedure can also be performed on the AV control-
ler by using its [DISPLAY] button.
The following information can typically be displayed for
input sources.
* If the input signal is analog, no format information is displayed.
If the input signal is PCM, the sampling frequency is displayed.
If the input signal is digital but not PCM, the signal format and
the number of channels is displayed. For some digital input sig-
nals, including multichannel PCM, the signal format, number of
channels, and sampling frequency is displayed.
Information is displayed for about three seconds, then the previ-
ously displayed information reappears.
Adjusting the Bass & Treble
1
AV controller
Press the [TONE] button repeat-
edly to select either “Bass” or
“Treble” for each speaker or sub-
woofer.
2
AV controller
Use the Up [r] and Down [e]
buttons to adjust.
Tip:
This procedure can also be performed
on the remote controller by using
[AUDIO] button (see page 112).
TONE, e, r DIMMER
DISPLAY
DISPLAY
DIMMER
MUTING
SLEEP
Press
[RECEIVER]
first.
Displaying Source Information
Remote
controller
Press the [RECEIVER] button,
and then press the [DISPLAY]
button repeatedly to cycle
through the available informa-
tion.
Sampling
frequency
Input source
Signal format*
Listening
mode
Input Signal
Resolution
Output
Resolution
To Next Page
Loading...
Need help?
General
