Onkyo TX-DS595 Service Manual

AMPLIFIER SECTION
Continuous Average Power output (FTC)
All channels: 75 W per channel min. RMS at 8
ohm, 2 channels driven from 20Hz
to 20 kHz with no more than
0.08% total harmonic distortion.
100 W min. RMS at 6 ohm , 2
channels driven from 1 kHz with
no more than 0.1% total
harmonic distortion.
Continuous Power output (DIN) 110 W at 6 ohm
Maximum Power output (EIAJ) 140 W at 6 ohm
Dynamic Power Output (Stereo) 2 210 W at 3
2 155 W at 4
2 90 W at 8
Total Harmonic Distortion: 0.08% at rated power
0.08% at 1 W output
IM Distortion: 0.08% at rated power
0.08% at 1 W output
Damping Factor: 60 at 8
Input Sensitivity and Impedance
PHONO: 2.5 mV, 50 k
LINE (CD, TAPE, DVD,
VIDEO 1,2,3): 200 mV, 50 k
MULTICHANNEL INPUT
(FRONT L/C/R, SURROUND L/R):
200 mV, 50 k
(SUBWOOFER): 36 mV, 50 k
COAXIAL 1, 2 (DIGITAL): 0.5 Vp-p, 75
DVD, VIDEO1,2,3: 1 Vp-p, 75
1 Vp-p, 75 (Y)
0.28 Vp-p, 75 (C)
Output Level and Impedance
Rec out (TAPE, VIDEO 1): 200 mV, 2.2 k
Pre out: 1 V, 470 ohm
VIDEO (VIDEO 1, MONITOR OUT):
1 Vp-p, 75 ohm
1 Vp-p, 75 ohm (Y)
0.28 Vp-p, 75 (C)
Phono Overload: 180 mV RMS at 1 kHz, 0.5% T.H.D.
Frequency Response: 10 Hz to 100 kHz: +1 dB, -
3 dB
RIAA Deviation: 20 Hz to 20 kHz : ±0.8 dB
Tone Control
Bass: ±10 dB at 50 Hz
Treble: ±10 dB at 20 kHz
Signal-to-Noise Ratio (Stereo)
Phono: 80 dB (IHF A, 5 mV input)
CD/Tape: 100 dB (IHF A, 0.5 V input)
Muting: 50 dB
TUNER SECTION
FM
Tuning Range: 87.5 to 108.0 MHz (50-kHz steps)
Usable Sensitivity
Mono: 11.2 dBf, 1.0 µV (75 ohm IHF)
0.9 µV (75 ohm DIN)
Stereo: 17.2 dBf, 2.0 µV (75 ohm IHF)
23 µV (75 ohm DIN)
50 dB Quieting Sensitivity
Mono: 17.2 dBf, 2.0 µV (75 ohm )
Stereo: 37.2 dBf, 20 µV (75 ohm )
Capture Ratio: 2.0 dB
Image Rejection Ratio:
USA & Canadian models: 40 dB
Other area models: 85 dB
IF Rejection Ratio: 90 dB
Signal-to-Noise Ratio
Mono: 76 dB
Stereo: 70 dB
Alternate Channel Attenuation: 55 dB
Selectivity: 50 dB (DIN)
AM Suppression Ratio: 50 dB
Total Harmonic Distortion
Mono: 0.2%
Stereo: 0.3%
Frequency Response: 30 Hz to 15 kHz, ±1.0 dB
Stereo Separation: 45 dB at 1 kHz
30 dB at 100 Hz to 10 kHz
AM
Tuning Range
USA & Canadian models: 530 to 1,710 kHz (10-kHz steps)
European & Australian models : 522 to 1,611 kHz (9-kHz steps)
Worldwide models: 531 to 1,602 kHz (9-kHz steps)
530 to 1,710 kHz (10-kHz steps)
Usable Sensitivity: 30 µV
Image Rejection Ratio: 40 dB
IF Rejection Ratio: 40 dB
Signal-to-Noise Ratio: 40 dB
Total Harmonic Distortion: 0.7%
GENERAL
Power Supply: AC 120 V, 60 Hz
(USA & Canadian models)
AC 230-240 V, 50 Hz
(European & Australian models)
AC 220-230 and 120 V switchable,
50/60 Hz (Worldwide models)
Power Consumption: 4.7 A
380 W
Dimensions (W H D): 435 175 431 mm
17-1/8" 6-7/8" 16-15/16"
Weight: 25.4 lbs. (USA & Canadian models)
12.5 kg (Other models)
REMOTE CONTROLLER
Transmitter: Infrared
Signal range: Approx. 5 meters, 16 ft.
Power supply: Two "AA " batteries (1.5 V 2)
Specifications and features are subject to change without notice.
Power supply and voltage vary depending on the area in which the
unit is purchased.
ohm
ohm
ohm
ohm
ohm
ohm
ohm
ohm
ohm
ohm
ohm
ohm
ohm
ohm
TX-DS595
SPECIFICATIONS

Onkyo TX-DS595 Specifications

General

Brand	Onkyo
Model	TX-DS595
Category	Receiver
Language	English