GENERAL INFORMATION
21
Battery Charge Cable Connector Type Metal Case 3-Pin XLR (female)
Battery (Charge Cycle) Life Rated for 800 Charge Cycles
Battery Charger – Standard Charge Separate External 84 VDC Output, Fixed Output 5 Amp Smart Charger, 110 VAC and 230 VAC Power
Cord
Battery Charger Output 5 Amps @ 84 VDC (recommended; standard rate charger)
Battery Charger Charge Cable Connector
Type
Metal Case 3-Pin XLR (male)
Battery Charger Charge Cable Connector
Pinout
Male - Pin 1 = DC+ (positive); Pin 2 = DC- (negative); Pin 3 = GND (ground/signal)
Battery Charger Protection Fuse Replaceable Fast-Blow Fuse
Typical Battery Charge Time – Empty to Full 80% Charge = 2.5 Hours
100% Charge = 4.5 Hours
Motor Controller Type Electronic Sine Wave
System & Motor Speed Controller Features High-Eciency 72V, 3000W (max.) Sinusoidal Wave Brushless DC (BLDC) Waterproof Motor Control-
ler with: Regenerative Power Support During Braking; Hardware Over-Current and Over-Voltage
Protection; LED Fault Code; Thermal and Current Cutback Plus Low Voltage Battery Protection
Shutdown; Rugged Waterproof Aluminum Housing for Maximum Heat Dissipation; Blue-tooth
(Android Support)
Motor Type 4T Turn Count Brushless DC (BLDC) Permanent Magnet 3000W Electric High Power Spoke Rear Hub
Motor with 3 Hall Sensors
Max. Motor Peak Torque 142 ft-lb (193N-m)
Motor Rated Power 750W (nominal in ECO Mode) up to 3,000W (maximum)
Motor Environmental Protection IP54
Motor Temperature Protection Thermic Probe (sense to prevent overheating)
Anti-Theft Protection Devices Audible Motion-Activated Alarm with Bike Activation/Deactivation Control and Power Button Fob
(set of 2 fobs provided); Uniquely Cut Key Lock for Battery Cover (set of 2 keys provided)
Anti-Theft Alarm dB Level 120 dB
Anti-Theft Alarm Frequency 433 MHz
Anti-Theft Alarm Fob Battery Type CR2032
Wiring Complete Insulated and Wrapped Wiring Harness with Automotive Water-Resistant Connectors
To Next Page
Loading...
Need help?
General
