OPERATING CONTROLS
RCR MODEL
34 LEFT SIDE CONTROLS
REAR REGENERATIVE BRAKE
The left brake lever not only controls the rear mechanical brake, but it also controls the regen braking. To activate
regen braking you only need to depress the lever slightly to activate the switch. Regen is very eective in not only
stopping the bike but also recharging the battery. If you are able to use the regen brake to safely stop the bike every
time you can dramatically increase your range. The sensitivity of this braking will be fully adjustable in the upcoming
mobile application. Warning: regenerative braking should not be used as a reliable means of stopping the bike. While
it works almost every time regen braking can stop working suddenly especially if the battery is near a full charge
because there is nowhere for the energy to go. Also when applying regen your throttle will be killed. So when you re-
lease the regen brake lever make sure you are not giving the throttle any power. For these reasons always use regen
braking with extreme caution.
HEADLIGHT SWITCH
To control the headlight you simply toggle the light switch up on the left hand control to activate the bright LED projec-
tor beam. The running lights are always on for safety and only use 0.1v in 5 hours of use. The main headlight does use
more volts and will drain the battery slightly faster so only use when needed. Note that because the headlight is very
bright, make sure you adjust the light so that it is not angled up and obstructing other driver’s vision.
HORN BUTTON
The horn button is located on the left hand controls and to activate the horn you simply depress the button.
BLINKER SWITCH
Each bike is outtted with a blinker switch for those who would like to add blinkers. To add blinkers you will need to
locate the blinker plug behind the left side panel and add your blinker relay/LED blinkers. Note: You must only use 12v
LED blinkers.
To Next Page
Loading...
Need help?
General
