OPERATING CONTROLS
31
HEADLIGHT
The headlight has two modes, Daylight and High Beam. The headlight is always on for increased visibility
and safety. See HANDLEBAR CONTROL OVERVIEW (p. 32)
BRAKE LIGHT
The brake light is located under the seat.
PEDALS
Pedals are used to manually propel the bike. Just keep in mind that this is a 145-lb bike with a single gear.
BATTERY
See BASIC BATTERY CHARGING PROCEDURE (p. 10) and BATTERY CHARGER AND OVERVIEW (p. 38)
BATTERY COVER
See BATTERY COVER REMOVAL AND INSTALLATION (p. 40-44)
REAR HUB MOTOR
Hub-driven 3000W motor.
ELECTRONICS COMPARTMENT
The electronics compartment houses the Speed Controller, Wiring Harness and Phase Wire conntec-
tions under the battery tray and is accessible by removing the aluminum side panels.
KICKSTAND
The kickstand should be used when the bike is parked and powered o. Use the kickstand on rm and
level ground to prevent the bike from falling over and causing damage.
To Next Page
Need help?
General
