RCR MODEL
42
BATTERY COVER INSTALL ATION
The battery cover is made of solid bamboo and should be handled with extreme care. Below are the steps for proper
installation of the cover so you do not break the cover. Never force, pry, or hit the cover or you could cause major
damage to the wood.
1: Place the front of the cover as far forward as pos-
sible with the sides under the top triple clamp. Make
sure the top of the cover is on top of the fork nut.
2: Gently bring down the back of the cover over the
battery chassis panel while doing your best to avoid
hitting the seat cover.
OPERATING CONTROLS
To Next Page
Loading...
Need help?
General
