Blinker Switch
Fig. 14
Running Lights On
Fig. 11
Horn Button
Fig. 13
Headlight On
Fig. 12
HEADLIGHT SWITCH
To control the headlight you simply toggle the light
switch up on the left hand control to activate the bright
LED projector beam. The running lights are always
on for safety and only use 0.1v in 5 hours of use. The
main headlight does use more volts and will drain the
battery slightly faster so only use when needed. Note
that because the headlight is very bright, make sure
you adjust the light so that it is not angled up and
obstructing other driver’s vision.
(Fig. 11 + 12)
HORN BUTTON
The horn button is located on the left hand controls
and to activate the horn you simply depress the button.
(Fig. 13)
BLINKER SWITCH
Each bike is outtted with a blinker switch for those who
would like to add blinkers. To add blinkers you will need
to locate the blinker plug behind the left side panel and
add your blinker relay/LED blinkers. Note: You must only
use 12v LED blinkers.
(Fig. 14 + 15)
To Next Page
Loading...
Need help?
General
