Oracle storagetek sl150 Reference Manual

Mode Sense (10)
154 SL150 Interface Reference Manual Julyl 2017
Phy Capabilities Data
TABLE 4-79 Phy Capabilities Data
Byte
Bit
76543210
0 Start (1B) TX SSC
Type
Reserved Requested Logical Link Rate
Supported Settings
1G1
Without
SSC
G1
With SSC
G2
Without
SSC
G2
With SSC
G3
Without
SSC
G3
With SSC
Reserved
2 Reserved (00h)
3 Reserved Parity
Phy Capabilities Data Definitions:
TX SSC Type The value 0 indicates that the phy's transmitter uses down-spreading SSC
when SSC is enabled (for example, the phy is a SAS phy), or that the phy does
not support SSC.
The value 1 indicates that the phy's transmitter uses center-spreading SSC
when SSC is enabled (for example, the phy is an expander phy).
Requested Logical Link
Rate
This field indicates if the Phy device supports multiplexing and, if so, the
logical link rate that the Phy device is requesting.
G1 Without SSC The Phy:
0 = Does not support G1 – 1.5 Gbps without SSC.
1 = Supports G1 – 1.5 Gbps without SSC.
G1 With SSC The Phy:
0 = Does not support – 1.5 Gbps with SSC.
1 = Supports G1 – 1.5 Gbps with SSC.
G2 Without SSC The Phy:
0 = Does not support G2 – 3 Gbps without SSC.
1 = Supports G2 – 3 Gbps without SSC.
G2 With SSC The Phy:
0 = Does not support G2 – 3 Gbps with SSC.
1 = Supports G2 – 3 Gbps with SSC.
G3 Without SSC The Phy:
0 = Does not support G3 – 6 Gbps without SSC.
1 = Supports G3 – 6 Gbps without SSC.
G3 With SSC The Phy:
0 = Does not support G3 – 6 Gbps with SSC.
1 = Supports G3 – 6 Gbps with SSC.
Parity The Parity bit shall be set to one or zero such that the total number of SNW-3
Phy device capabilities bits that are set to one is even, including the Start bit
and the Parity bit.

Oracle storagetek sl150 Specifications

General

Brand	Oracle
Model	storagetek sl150
Category	Storage
Language	English