%&'"()*+,,-,,.".
4.1.4.7 GSM Antenna
Connector type FAKRA Plug male type D(Bordeaux)
Mating connector FAKRA jack female type D(Bordeaux)
Location Front panel
7 GSM antenna connector characteristics
To keep the IP67 waterproof features, a special fakra connection is needed,
with code AIMMET 3659NTG14D1. Please contact Owasys to get more
information on this connector.
4.1.4.8 GNSS Antenna
owa4x products have a built-in GNSS module. Use only external GNSS active
antenna connected to the GNSS connector provided in the front panel.
Connector type FAKRA Plug male type C(blue)
Mating connector FAKRA jack female type C(blue)
Location Front panel
8 GNSS antenna connector characteristics
By means of internal circuitry, the owa4x is able to detect if the GNSS antenna
is operating correctly, if there is an open circuit or a short circuit.
To keep the IP67 waterproof features, a special fakra connection is needed,
with code AIMMET 3659NTG14C1. Please contact Owasys to get more
information on this connector.
4.1.4.9 LEDs
There are 6 LEDs, 4 at the front of the owa4x, see 2, and 2 at the rear with the
optional Ethernet RJ45 connector, see 2.
These are the LEDs colours and functions:
Name Colour Indication Comment
GNSS Orange GNSS activity Can be controlled by user
STATE Red As defined by application Controlled by user
PWR Green As defined by application Controlled by user
RADIO Yellow GSM activity Can be controlled by user
LINK Green Ethernet Link Controlled by ETH (optional)
100 Mbps Yellow Ethernet 100Mbps Controlled by ETH (optional)
9 LEDs description
The green LED on owa4x is user programmable. For more information about
the control of the Red LED, see owa4x Family Programming Guide.
The yellow LED is used to indicate the status of the GSM Module as shown in
the table below:
GSM Module State Yellow LED
OFF Off
/+
To Next Page
Loading...
General