Panasonic KX-NS500 Getting Started

4.2 Programming SIP Trunks
The Virtual 16-Channel SIP Trunk Card
(V-SIPGW16) is a virtual trunk card which is designed to be easily
integrated into an Internet Telephony Service provided by an ITSP (Internet Telephony Service Provider).
For information about SIP trunks, refer to "8.4 SIP Trunks" in the Installation Manual.
Accessing Port Properties
1.
Click Setup ® PBX Configuration ® Configuration
® Slot.
2. Place the mouse cursor over the Virtual Slot,
and in the
menu that appears, click Select Shelf.
3. Move the mouse pointer over the V-SIPGW16 card to
display the menu of options, and then click Ous.
4. Move the mouse pointer over the V-SIPGW16 card to
display the menu of options again, and then click Port
Property.
Programming Port Properties
Automatic Programming
Some of the parameters can be automatically programmed by selecting the desired SIP provider for each
virtual
SIP gateway port. Available SIP providers can be selected, and a different SIP provider can be assigned
to each virtual SIP gateway port.
Note
It is necessary to import a SIP provider list file (comma-separated value [CSV] file) in advance to use the
automatic programming feature.
Follow the steps below to configure a SIP provider.
1. Click Select Provider.
A dialogue box will appear. Available virtual SIP gateway port numbers are displayed in the list.
2. From the Provider drop-down list, select the desired SIP provider.
Note
If the desired SIP provider is not shown in the drop-down list, it is necessary to programme the desired
parameters manually. For information about the manual programming procedure, refer to "Manual
Programming" below.
3. Highlight the desired port numbers or click Select All to select all the virtual SIP gateway port numbers to
be assigned to the SIP provider selected in step 2.
4. Click Execute.
Appropriate setting values designated by the SIP provider will be set in the parameters for the virtual SIP
gateway ports.
Manual Programming
Manual programming is compulsory for the following parameters:
Follow the steps below to programme the parameters which are not automatically programmed by selecting a
provider.
1. Click the desired tab.
2. Enter information or select settings from the drop-down list for each parameter.
36 Getting Started
4.2 Programming SIP Trunks

Panasonic KX-NS500 Specifications

General

Analog Extensions	Up to 64
VoIP Support	Yes
System Type	Hybrid IP-PBX
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	0°C to 40°C
Humidity	10% to 90% (non-condensing)
Maximum Extensions	288
IP Extensions	128
VoIP Channels	64
SIP Trunks	64
Networking	Yes, supports networking
Built-in Applications	Call Center
Expandability	Yes, via expansion cards and cabinets
Supported Protocols	SIP, H.323, MGCP
Dimensions	430 x 88 x 367 mm