Preparation
16
VQT0V10
• Do not remove the card or the batteries
while the camera accesses the built-in
memory or a card. The data may be
damaged. (P16)
• Remove the batteries after the LCD
monitor and the status indicator
(green) turn off. Otherwise, the settings
on the camera may not be stored
properly.
Inserting/Removing
the Card (Optional)
• Check that the camera is turned off and
that the lens is retracted.
• You can record or play back pictures
on the built-in memory when you are
not using a card. (P16)
1 Slide the card door to open it.
2 Insert:
Insert the card fully until it clicks
and it is locked.
Remove:
Push the card until it clicks, then
pull the card out upright.
• Check the direction of the card.
• Do not touch the connection terminals
on the back side of the card.
• The card may be damaged if it is not
fully inserted.
3 1 Close the card door.
2 Slide the card door to the end
and then close it firmly.
• If the card door cannot be completely
closed, remove the card and insert it
again.
• The card and the data may be damaged
if it is inserted or removed while the
camera is on.
• We recommend using Panasonic’s SD
Memory Card.
About the Built-in
Memory/the Card
∫ Built-in Memory [ ]
You can record or play back pictures on
the built-in memory when you are not
using a card.
• The built-in memory capacity is about
14 MB.
∫ Card [ ]
You can record or play back pictures on
a card.
(The built-in memory cannot be used
when a card is inserted.)
∫ Access to the built-in memory or the
card
• The access indication lights red when
pictures are being recorded on the built-in
memory (or the card).
VQT0V10ENG.book 16 ページ ２００５年１２月２７日 火曜日 午後８時３４分
To Next Page
Loading...
Need help?
General
