Advanced
37
VQT0V10
The LCD monitor becomes easier to see
when the camera is held in the following
position. This is useful when you cannot get
close to the subject because there is a
person in the way.
Press [HIGH ANGLE] A for
1 second to display the High
angle mode icon [ ] B.
• High angle mode is activated. The LCD
monitor becomes brighter and easier to
see when the camera is held away from
you. (However it becomes more difficult
to see when looked at straight on.)
∫ Canceling High angle mode
Press and hold [HIGH ANGLE] again for
1 second or turn the camera off.
• High Angle mode is also canceled if
power save mode is activated.
• Pictures are displayed on the LCD monitor
with increased brightness in High angle
mode. Therefore, some subjects may look
different on the LCD monitor. However,
this does not affect the recorded pictures.
• You may not notice the High angle mode
effect if the LCD monitor is difficult to see
because of light from the sun etc. shining
on it. In this case, we recommend using
your hand or another object to block the
light when using the camera.
• High angle mode is not activated in the
following cases:
– In simple mode [ ]
– In playback mode
– While the menu screen is displayed
– During Review
Recording a picture with the
camera held high above your head
(High angle mode)
SCN1
SCN
2
3
FOR 1 SEC.
3
HIGH
ANGLE
ON :
PRESS
VQT0V10ENG.book 37 ページ ２００５年１２月２７日 火曜日 午後８時３４分
To Next Page
Loading...
Need help?
General
