114
English
8
Select [Execute] with and press
<ENTER>.
EQ1-001
EQ1-002
EQ1-004
EQ1-005
EQ1-014
EQ1-006
EQ1-041
EQ1-009
192.168. 0. 1
192.168. 0. 2
192.168. 0. 4
192.168. 0. 25
192.168. 0. 31
192.168. 0. 7
192.168. 0.124
192.168. 0.211
LAN data cloning
Status
Execute
Display name IP address
Select display
OffWrite protect
Note
●
Data cannot be copied to the display for which
[Write protect] is set to [On]. Set this to [On] to
prevent [LAN data cloning] from being performed
mistakenly when data copy is not necessary.
●
Once [LAN data cloning] is performed, [Write
protect] is set to [On].
9
A confirmation window appears.
Select [Execute] with
and press
<ENTER>.
LAN data cloning
All data for the selected displays will be changed.
Are you sure you want to execute?
Execute Return
Data copy to the display starts.
LAN data cloning
Cloning in progress, please wait.
DO NOT unplug your Display!
10
The exit screen appears.
The green mark on the list shows the data has been
copied successfully. The red mark shows failure.
If the red mark appears, check the LAN cable
connection or power status of the display of the copy
destination.
EQ1-001
EQ1-002
EQ1-004
EQ1-005
EQ1-014
EQ1-006
EQ1-041
EQ1-009
192.168. 0. 1
192.168. 0. 2
192.168. 0. 4
192.168. 0. 25
192.168. 0. 31
192.168. 0. 7
192.168. 0.124
192.168. 0.211
LAN data cloning
Status
Cloning finished.
Display name IP address
If the data copy has finished, the message appears
on the display of the copy destination.
Cloning finished. Please turn off the power.
11
Switch the <Main Power On / Off
button> ( ) on the unit of the copy
destination to ( ) to turn the power
off.
The copied content is applied to the display.
●
If the <Main Power On / Off button> is locked,
please disconnect the AC cord plug from the wall
outlet.
Note
●
If the data is copied with [POWER button lock] set to
[On], this function operates after turning the power
off, and the <Main Power On / Off button> cannot be
used to turn the power on. In this case, remove the
power plug, wait sufficient time, and then connect the
power plug again to turn the power on.
Changing the cloning password
Changes the cloning password required
to use the cloning function.
1
Insert the USB memory device to
the USB terminal at the side of the
display.
The password input screen is displayed.
2
Enter the current password, and press
[Ok].
3
Enter the new password, and press
[Ok].
4
Enter the new password again for
confirmation, and press [Ok].
Note
●
The initial password in the factory default state is
[AAAA].
●
Change the password periodically, and set one which
is difficult to guess.
●
For initialization method for the cloning password,
consult the dealer where you purchased the product.
To Next Page
Loading...
Need help?
General