33
English
Selecting the input signal
Select the signals input to the unit.
Press <INPUT> or <INPUT (Unit)>.
Unit
MENU ENTERINPUT
+
-
Switches input every time the buttons are pressed.
PC
Full
[HDMI1] → [HDMI2] → [DVI-D] → [PC] → [VIDEO] →
[USB] → [MEMORY VIEWER]
[HDMI1]: HDMI 1 terminal, HDMI input
[HDMI2]: HDMI 2 terminal, HDMI input
[DVI-D]: DVI-D IN terminal, DVI-D input
[PC]
*
: PC IN terminal, PC input
[VIDEO]: AV IN terminal, composite video input
[USB]: USB terminal, USB input
[MEMORY VIEWER]: USB terminal, “Memory viewer”
input
*
: [PC] may be displayed as [PC[YP
BPR]] depending on
the settings of [PC input mode]. (see page 75)
Note
●
Displays the signal name as set in [Input label]. (see
page 57)
●
Input will not be switched unless [Input lock] is set to
[Off]. (see page 61)
●
To switch between the component (colour difference)
video and RGB for the PC IN terminal, make the
setting with [Setup] - [PC input mode]. (see page 75)
●
Image retention (image lag) may occur on the LCD
liquid crystal panel when a still picture is kept on
the panel for an extended period. To prevent such a
problem, using the screensaver and the [Wobbling]
function is recommended. (see page 56, 57)
RECALL
It is possible to check the setting status of input label,
picture mode, etc.
Press <RECALL>.
Current setting status will be displayed.
10:00
HDMI1
Full
AV IN
Memory name: MEMORY2
Schedule play mode
Off timer
90 min
Backup mode OK
1 Input label
2 Aspect mode (see page 35)
3 Backup input change (see page 54, 55)
4 Audio input (see page 59)
5 Profile name (see page 47)
6 [Schedule play mode] (see page 102)
7 Off timer remaining time (see page 34)
8 Clock / Mute (see page 34, 65)
●
When there is no video signal to the selected input,
[No signal] is displayed for about 30 seconds at the
end.
●
When a USB memory is not connected to the USB
terminal at the time of switching to the USB input, [No
external media] is displayed for about 30 seconds.
Even when a USB memory is connected, if it does not
contain any playable file, [No play file] is displayed at
all times.
●
When [No signal image settings] - [Display setting] is
set to [On] (see page 61), the message [No signal] /
[No external media] / [No play file] are not displayed.
Instead, the image set in [No signal image settings]
will be displayed.
●
To display the clock, set [Date and time] and then set
[Clock display] to [On]. (see page 64)
To Next Page
Loading...
Need help?
General