2-5
4. Raise the output tray to avoid the printed paper from slipping and falling.
2.3.2. LOADING INTO THE MANUAL FEEDER TRAY
1. Raise the output tray to avoid the printed paper from slipping and falling, or immediately
remove the printed document after the printing is complete.
2. Open the manual feeder tray.
Note: • It is recommended that you raise the output tray to prevent the paper from
slipping and falling after printing. If you choose not to raise the output tray, we
recommend that you immediately remove the printed paper from the printer.
• If the quantity of paper loaded into the standard tray at any one time exceeds
250 sheets (80g/m
2
), the paper may jam or may not feed effectively.
• If carrying out single-sided printing, please make sure that the side to be printed
(the blank side) is face down.
To Next Page
Loading...
Need help?
General