2-8
Note: • The printer tray is designed with the "paper type dial" for commonly used paper
size, which can be adjusted as required. When the paper type used for printing is
different from that the dial sets, the LCD display of the printer will show "Optl tray
I, PaprSize Mismat." indicating an error, then it is necessary to reset the dial to
eliminate the error.
• For those paper types that are not shown on the dial, please set up the paper
size through the control panel.
4. Raise the output tray to avoid the printed paper from slipping and falling.
Note: • If the paper loaded into the optional tray at one time exceed 550 pages
(80 g/m²), paper will jam or cannot be fed in.
• If printing only the single side, please make the side to be printed (the blank
side) down.
• For installation of the optional tray, please refer to the Installation Guide
attached with the optional tray.
2.3. Non-printing Area
The shaded section indicates the non-printing area.
Usage Paper Size
Top and Bottom
Margins (A)
Left and Right
Margins (B)
Print
A4 5 mm (0.197 in) 5 mm (0.197 in)
Letter 5 mm (0.197 in) 5 mm (0.197 in)
To Next Page
Loading...
Need help?
General