4-20
Manual Setting
Enter the IP address in the Web browser's address bar to open the embedded Web server.
1. Click Settings in the navigation bar to open the Settings page;
2. Select Network Settings - IPV4 Settings;
3. Set IP Address Assignment Mode (Manual), IP Address and Subnet Mask. Other items are
optional;
4. Click Apply to save the settings.
Note: • You can use the embedded Web server to change the IP Address Assignment
Mode into Automatic or Manual.
• To reset all the parameter settings of the printer, users can restore to the factory
settings, and please refer to Chapter 6 for the specic operations.
4.3.2. Control Panel Settings
Users can set up the wired network and wireless network through the Control Panel menu.
4.3.2.1. Network Settings
Users can set the network status through Network Settings.
1) Press "Menu" to enter the Menu Settings interface.
2) Press direction key "▲" or "▼" to select the "4.Network Set" option and press "OK".
3) Press direction key "▲" or "▼" to select the "1.Wired Cong" and press "OK"; Press
direction key "▲" or "▼" to select "1.IPv4" or "2.IPv6".
To Next Page
Loading...
Need help?
General