Parker D1VW EE Series User Manual

D1VW_EE 5715-690 UK.indd 11.07.22
Directional Control Valve
Series D1VW Explosion Proof Operating Instructions
13
Parker Hannin Corporation
Pressure uids
The following rules applies for the operation with
various pressure uids:
This information serves for orientation and
does not substitute user tests among the
particular operating conditions. Particularly
no liabiliy for media compatibility may be
derived out of it.
Mineral oil: usable without restriction.
For operation with the following pressure uids
please consult Parker:
For detailed information concerning pressure
uids note VDMA-document 24317 as well as
DIN 51524 & 51502.
Special gaskets may be available depending on
the utilized uid.
In case of insecurity please consult Parker.
The pressure uid must have an ignition tempera-
ture of at least 50 K above the maximum surface
temperature of the valve (see EN 13463-5 and IEC
60079-4).
Electrical connection
Observe operating instructions D14-2128D3-* and
K14-2074D3-* in the annex.
Operation limits
The valve may only be deployed with the specied
limits of use. The relevant details can be found in
the catalogue sheet under "Technical data" and
"Characteristic curves".
Observe the ambient conditions. Unau-
thorised temperatures, shocks, the e󰀨ects
of aggressive chemicals, radiation, unau-
thorised electromagnetic emissions may
result in disruptions and failures. Observe
the limits of operation set out in "Technical
data".
Excessive temperatures may cause the so-
lenoid to overheat, creating the risk of ex-
plosion. To permit adequate heat dissipati-
on, the solenoid coil should not be painted.
Size 6, mounting pattern ISO 4401-03-03-0-05
HFA oil-in-water emulsion
HFB water-in-oil emulsion
HFC aqueous solution (glycols)
HFD unhydrous uids (Phosphor-Ester)

Parker D1VW EE Series Specifications

General

Brand	Parker
Model	D1VW EE Series
Category	Control Unit
Language	English