Parkside POF 1200 C2 User Manual

30
GB MT
1. Press the spindle locking button
(16) on the front side of the ma-
chine and keep it pressed down.
2. Use the combination wrench (27)
to loosen the cap nut (8) as much
as needed, so that the cutter can
be inserted.
3. Release the spindle locking but-
ton (16).
4. Insert the desired cutter into the
already mounted collet chuck
(13). The cutter shaft must be
pushed in at least 20 mm.
5. Use the combination wrench (27)
to tighten the cap nut (8) while
keeping the spindle locking but-
ton (16) pressed.
Tighten the cap nut only when a
cutter is inserted. The collet chuck
might get damaged.
Change collet chuck
All cutters of the 6-part cutter set included
in the delivery are provided with an 8-mm
cutter shaft.
Change the collet chuck for cutters with a
6-mm cutter shaft.
1. Press the spindle locking button
(16) on the front side of the ma-
chine and keep it pressed down.
2. Screw off the cap nut (8) using
the combination wrench ( 27).
3. Release the spindle locking but-
ton (16).
4. Take out the 8mm collet chuck
(13) and insert the 6mm collet
chuck (22) and the spring (37)
included in the delivery in the
sequence shown in the diagram.
5. Screw the cap nut (8) loosely
back on.
6. Insert a cutter as described above
.
Tighten the cap nut only when a
cutter is inserted. The collet chuck
might get damaged.
Connecting the suction
adapter
You can reduce dust formation while you
work by connecting a dust suction system.
1. Fit the suction adapter (20) on
the provided drill holes ( 12)
in the baseplate (10).
2. Screw on the 2 recessed head
screws (21) from the bottom side
of the baseplate (10).
3. Fit the reducer part (30) on the
suction adapter if needed.
4. Connect the suction hose of a
vacuum cleaner to the suction
adaptor (20).
The vacuum cleaner must be suit-
able for the workpiece to be pro-
cessed.
Use a special vacuum cleaner if
dusts with hazard for health are cre-
ated.
Mounting the parallel stop
1. Screw both screws out of the
guide bars (29).
2. Screw the guide bars (29) onto
the parallel stop (24) using the
spanner (27).

Parkside POF 1200 C2 Specifications

General

Brand	Parkside
Model	POF 1200 C2
Category	Wood Router
Language	English