Parkside PTBM 500 E5 User Manual

11
CY
IE NI
tation of the rotary wheel. Long
drilling chips may cause injury.
• Keep handles dry, clean and
free from oil and grease. Greasy,
oily handles are slippery and lead to
loss of control.
• Use clamps to hold the workpie-
ce in place. Do not work on any
workpieces that are too small for
clamping. If you hold the workpiece by
hand, you cannot hold it sufciently tight-
ly against rotation and may hurt yourself.
• Switch the power tool off imme-
diately if the bit jams. The bit jams
when:
- the power tool is overloaded or
- the workpiece to be machined is
jammed.
• Do not touch the bit after wor-
king before it has cooled down.
The bit is very hot during use.
• Inspect the cable regularly and
have a damaged cable repaired
only by an authorised customer
service centre. Replace damaged
extension cables. This will ensure
that the power tool remains safe.
• Store unused power tools in a
safe place. The storage place
should be dry and lockable. This
prevents the power tool from being
damaged as a result of being stored or
operated by inexperienced people.
• Never leave the tool before it has
come to a complete standstill.
After-running bits can cause injury.
• Do not use the power tool with
a damaged cable. Do not touch
the damaged cable and pull the
mains plug if the cable is da-
maged while working. Damaged
cables increase the risk of electric shock.
• The device is unsuitable for processing
of foods.
• Edit not work pieces that you can not
sure retain. Especially round or uneven
workpieces.
• Avoid abnormal body postures.
Ensure secure footing and keep your
balance at all times.
• Stand while working with the
device in such a way that you can
operate the hand spindle guide fea-
turing 3 drill lifting arms with the right
hand, and the on/off switch with the
left hand.
Safety Instructions for
Handling the Laser
– Caution: Laser radiation - Do not look into
the beam - Laser class 2
– Do not aim the laser at reective surfaces.
– Markings and warnings are located next
to the hand spindle guide (9).
Safety Instructions for
Handling Batteries
• Ensure at all times that the batteries are
inserted with the correct polarity (+ and
–), as shown on the battery itself.
• Do not short-circuit the batteries.
•
Do not charge non-rechargeable batteries.
• Do not overcharge batteries!
• Do not mix old and new batteries or
batteries of a different type or from
different manufacturers! Replace all bat-
teries of a set at the same time.
• Remove used batteries immediately
from the device and dispose of them
correctly!
• Do not heat the batteries!
• Do not carry out any welding or solde-
ring work directly on the batteries!
• Do not take the batteries apart!
• Do not deform the batteries!
• Do not throw the batteries into re!

Parkside PTBM 500 E5 Specifications

General

Brand	Parkside
Model	PTBM 500 E5
Category	Drill
Language	English