WARNINGS AND SAFETY INSTRUCTIONS 2/3
Water temperature in excess of 38° C (100° F) may be hazardous to your health. Prolonged
immersion in hot water may induce hyperthermia. Hyperthermia occurs when the internal
temperature of the body reaches a level several degrees above normal body temperature
of 37° C (98.6° F). The symptoms of hyperthermia include: drowsiness, lethargy, dizziness,
fainting, and an increase in the internal temperature of the body.
The effects of hyperthermia include:
1. Unawareness of impending danger.
2. Failure to perceive heat.
3. Failure to recognize the need to leave the spa.
4. Physical inability to exit the spa.
5. Fetal damage in pregnant women.
6. Unconsciousness resulting in danger of drowning.
WARNING - WATER TEMPERATURE
OTHER WARNINGS
• The use of alcohol, drugs, or medication can greatly increase the risk of gatal hyperthermia
in hot tubs and spas.
• To reduce the risk of injury, do not permit children to use this product.
• For units intended for use in other than single-family dwellings, a clearly labeled
emergency switch shall be provided as part of the installation. The switch shall be readily
accessible to the occupants and shall be installed at least 1.52m (5 feet) away, adjacent
to, and within sight of the unit.
• When setting up flow rates, the operator must consider local codes governing turnover as
well as disinfectant feed ratios.
• Before servicing the system, switch the main power OFF and remove the communication
cable from the pump.
• Install the pump a minimum of 1.5m (5 feet) from the inside wall of the pool and spa.
• This pump is for use with permanently installed pools and may also be used with hot tubs
and spas if so marked. Do not use with storable pools. A permanently installed pool is
constructed in or on the ground or in a building such that it cannot be readily disassembled
for storage. A storable pool is constructed so that it may be readily disassembled for
storage and reassembled to its original integrity and has a maximum dimension of 5.49m
(18 feet) and a maximum wall height of 1.07m (42 inches).
• For hot tubs and spa pumps, do not install within an outer enclosure or benaeth the skirt
of a hot tub or spa unless so marked.
• IntelliFlo
®
VSD2 is capable of generating system pressures up to 30 meters. Installers
must ensure that all system components are rated to withstand at least 30 meters. Over
pressurizing the system can result in catastrophic component failure or property damage.
5
!
!
To Next Page
Loading...
Need help?
General
