3
S536 (11-25-19)
SAFETY
Carefully read and follow all safety instructions in this manual
or on pump.
This is the safety alert symbol. When you see this symbol on your
pump or in this manual, look for one of the following signal words and
be alert to the potential for personal injury.
warns about hazards that will cause serious personal
injury, death or major property damage if ignored.
warns about hazards that can cause serious personal
injury, death or major property damage if ignored.
warns about hazards that will or can cause minor
personal injury or property damage if ignored.
The label NOTICE indicates special instructions which are important
but not related to hazards.
Keep safety labels in good condition. Replace any missing or damaged
ones.
California Proposition 65 Warning
This product and related accessories contain chemicals
known to the State of California to cause cancer, birth defects or
other reproductive harm.
ELECTRICAL SAFETY
Wire motor for correct voltage. See “Electri cal” section of this
manual and motor nameplate.
Ground motor before connecting to power
supply.
Meet National Electri cal Code, Canadian Elec tri cal Code, and
local codes for all wiring.
Follow wiring instructions in this manual when connecting
motor to power lines.
GENERAL SAFETY
Hazardous pressure! Install pressure relief
valve in discharge pipe.
Release all pressure on system before working
on any component.
Do not touch an operating motor. Modern motors can
operate at high temperatures. To avoid burns when servicing pump,
allow it to cool for 20 minutes after shut-down before handling.
Pump is designed as a lawn sprinkler only. To avoid heat built-up, over
pressure hazard and possible injury, do not use in a pressure tank
(domestic water) system. Do not use as a booster pump; pressurized
suction may cause pump body to explode.
Do not allow the pump or piping to freeze. Freezing can cause
equipment failure that leads to injury and voids warranty.
Pump water only with this pump.
Periodically inspect pump and system components.
Wear safety glasses at all times when working on pumps.
Keep work area clean, uncluttered and properly lighted; store properly
all unused tools and equipment.
Keep visitors at a safe distance from the work areas.
Make workshops childproof; use padlocks and master switches;
remove starter keys.
Hazardous voltage. Can shock, burn, or cause
death.
Ground pump before connecting to power supply.
To Next Page
Loading...
Need help?
General
