Compact Fieldbus Power Hub,Generic Interface
Safety
2014-10
5
1Safety
1.1 Validity
Specific processes and instructions in this document require special precautions to guarantee
the safety of the operating personnel.
1.2 Symbols used
This document contains information that you must read for your own personal safety and to
avoid property damage. Depending on the hazard category, the warning signs are displayed in
descending order as follows:
Safety-relevant symbols
Informative symbols
Action
This symbol indicates a paragraph with instructions.
1.3 System Operator and Personnel
Responsibility for planning, assembly, commissioning, operation, maintenance, and
dismounting lies with the plant operator.
Mounting, installation, commissioning, operation, maintenance and disassembly of any
devices may only be carried out by trained, qualified personnel. The instruction manual must
be read and understood.
1.4 Pertinent Laws, Standards, Directives, and further Documentation
Laws, standards, or directives applicable to the intended use must be observed. In relation to
hazardous areas, Directive 1999/92/EC must be observed.
The corresponding datasheets, declarations of conformity, EC-type-examination certificates,
certificates and Control Drawings if applicable (see datasheet) are an integral part of this
document. You can find this information under www.pepperl-fuchs.com.
Due to constant revisions, documentation is subject to permanent change. Please refer only to
the most up-to-date version, which can be found under www.pepperl-fuchs.com.
Danger!
This symbol indicates an imminent danger.
Non-observance will result in personal injury or death.
Warning!
This symbol indicates a possible fault or danger.
Non-observance may cause personal injury or serious property damage.
Caution!
This symbol indicates a possible fault.
Non-observance could interrupt devices and any connected systems and plants, or result in
their complete failure.
Note!
This symbol brings important information to your attention.