Pack away after sewing
1. Switch the main switch off.
Note: After switching off, residual power may still remain in
the machine. This may cause the light to stay on for a few
seconds while the power is consumed. This is normal behavior
for an energy efficient appliance.
2. Unplug the cord from the wall socket and then from
the machine.
3. Unplug the foot control cord from the machine.
Wind the cord around the foot control for easy
storage.
4. Place all accessories in the accessory tray. Slide the
tray on to the machine around the free arm.
5. Place the foot control in the space above the free arm.
6. Put on the hard cover.
Free arm
To use the free arm, slide off the accessory tray. When
attached, a hook keeps the accessory tray securely
attached to the machine. Remove the tray by sliding it to
the left.
Leveling the machine base plate
To make sure your machine stands steadily on your
sewing surface you can adjust the base plate height.
Turn the base plate adjusting screw (A) by hand. Turn
clockwise to lower and counter-clockwise to raise the
base plate.
Thread cutter
To use the thread cutter, pull the thread from back to
front as shown (B).
11
To Next Page
Loading...
Need help?
General
