Accessories
Included accessories
1. Bobbins (3) (#416475801)
2. Felt pad
3. Screwdriver for needle plate
4. Multi-purpose tool
5. Spool cap, large
6. Spool cap, small
7. Seam ripper & brush (as one)
8. Edge/Quilting guide
9. Auxiliary spool pin
Included accessories not in picture
• Foot control
• Power cord
• Needles
• Hard cover
Presser feet
Standard presser foot 0
(shown as 0 in the LED Display, attached on the machine upon delivery)
This foot is used mainly for straight stitching and zigzag stitching with a stitch length longer
than 1.0 mm.
Fancy stitch foot 2A
(shown as 2A in the LED Display)
When sewing decorative stitches or short zigzag stitches and other utility stitches with less
than 1.0 mm stitch length, use this foot. The groove on the underside of the foot is designed
to flow smoothly over the stitches.
Blindhem foot 3
(shown as 3 in the LED Display)
This foot is used for blindhem stitches. The toe on the foot guides the fabric. The red guide
on the foot is designed to ride along the fold of the hem edge.
Note: Always use at least 5mm stitch width when using Blind Hem Foot 3. If using a stitch width
other than the recommended, swing the needle by turning the hand wheel to make sure the needle
doesn’t hit the metal pin in the foot.
Zipper foot 4
This foot can be snapped on either the right or the left of the needle, making it easy to sew
close to both sides of the zipper teeth. Move the needle position to the right or left to sew
closer to zipper teeth.
One-Step Buttonhole Foot 5B
(shown as 5B in the LED Display)
This foot has a space in the back for a button used to set the size of the buttonhole. The
machine will sew a buttonhole to fit that button size.
7
To Next Page
Loading...
Need help?
General
