Sound/Warning messages
Machine sound
It is possible to turn off the sound on the machine
buttons. Press the immediate tie-off button while
turning on the machine. Select between the audio on or
off by touching the stitch width “+” or “–” buttons.
Touch “-” to turn off the audio and the display will
show “0”.
Touch “+” to turn on the audio and the display will
show “1”.
Press the immediate tie-off button again to return to
sewing mode.
Bobbin winding position
When the bobbin spindle is pushed to the right, the
letters “SP” flash on the LED display. If you press any
button, a beep will inform you to push the bobbin
winder spindle to the left, sewing position.
Note: You cannot sew in bobbin winding position.
Main motor overload
Your sewing machine can get overloaded when sewing
on heavy fabrics e.g. the thread gets twisted or jammed
or the handwheel axle cannot move. A monotone beep
sound is heard and the letters "EL" flash on the LED
display. Please refer to the troubleshooting section to
find a recommended solution. When the problem has
been solved, the machine will continue to sew.
Note: When sewing, if the thread gets jammed inside the hook
preventing the needle from moving and you continue pressing
the foot control, the security switch will stop the machine
completely. Restart the sewing machine by switching the ON/
OFF switch to the OFF position and then ON again.
Note: If the problem is still not solved, please contact your
local authorized PFAFF® dealer.
22
To Next Page
Loading...
Need help?
General
