Update software
Philips continuously tries to improve its products and we strongly
recommend that you upgrade the TV software when upgrades are
available.
New software can be downloaded from our website at
www.philips.com/support using the model number of your TV to find
information.
You can update the software through these methods:
•
Update with USB memory stick
•
Update from digital broadcast Update notification
p. 43
This section describes how to upgrade the software by using USB memory
stick.
Preparing for the software upgrade
You require the following equipment:
–A PC with web browsing capability
–An archive utility that supports the ZIP-format
(e.g. WinZip for Windows or StuffIt for Mac OS)
–An empty clean formatted USB memory stick
Note(s)
•
Only FAT / DOS-formatted portable memory is supported.
•
Use only software upgrades that can be found on the Philips web site.
Warning
•
When the software upgrade is running, don’t press any buttons.
•
Do not remove the USB memory stick during the software upgrade.
•
If an error occurs during the upgrade, retry the procedure or for further assistance, please contact
call center.
Downloading the software
Find information and software related to your TV and download the latest
software upgrade file to your PC.
Prepare a blank USB memory stick for software update. Access
www.philips.com/support and download the latest version software to
a blank USB memory stick using a PC by following the directions described
on the website.
•
Use a blank USB memory stick, download the software on your PC and
write the software in the root directory of the USB memory stick.
•
For more details on how to download the software, please refer to the
website.
USB upgrade
You can upgrade the software by using USB memory stick.
1
Connect your USB memory stick with the upgrade file to the USB
terminal on the side of your TV.
2
Press and use to select Setup, then press OK.
3
Use to select Update software, then press OK.
4
Use to select USB, then press OK.
5
Use to select the desired update file, then press OK.
6
Use to select Yes, then press OK.
•
Read the on-screen instructions and confirm that you want to
continue with the installation.
Do not remove the USB storage device or turn the TV o
while upgrade is in progress.
Software update is in progress. Please wait.
7
When the software upgrade is completed, press to set the unit into
standby mode, then remove the USB memory stick.
8
Unplug the AC power cord for a few seconds from AC outlet and plug
it again.
9
Press again to turn the unit on.
•
The TV starts up with the new software.
•
For further assistance, please contact call center.
42 .English
Continued on next page.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
